1. Connect the scanner to your computer using the USB cable.

2. Scan the following barcode to put the scanner into "Carriage Return/Line Feed" mode.

3. Login to CleanCloud and go to the Barcode Scanner section at the bottom of Settings > Hardware > Barcode Scanner.

4. Enable the 'Use Barcode Scanner' option and press the Update button.

5. Now when you scan a barcode that was printed from CleanCloud the software should be able to interpret the barcode.

If your barcode scanner does not work when scanning a receipt the most common problem is that the barcode scanner is not submitting an Enter or Carriage Return command after each scan.

If this is the case then reset the scanner by scanning this barcode:

Now go back to Step 2 above and scan the Carriage Return barcode before scanning the CleanCloud receipt again.